103 High Street, Andover, Hampshire, SP10 1ND
Call Us 01264 355982

Servicing & Repairs

We have a fully equipped workshop with 2 mechanics both of which have been with us for over 15 years.

From simple punctures to updating the latest Shimano Di2 and Bosch E Bike servicing we cater for all.

Servicing Menu

Cycle Service £35.00
Di2 and E Bike service £65.00

Includes set up of gears and brakes to correct adjustment and assessment of condition/wear. Bottom bracket, wheel hubs and headset checked for condition and proper adjustment and adjustments made as necessary. Wheels checked for trueness and correct spoke tension with minor adjustments covered. Tyres checked for condition and inflated to correct pressure. All fastenings checked and tightened as necessary and cycle test ridden to confirm all ok.

Di2 & E Bike service includes the above, plus firmware/software update of system and diagnostics run.

Shimano Spec Gold Service From £180.00

Full strip down of cycle to frame. All components cleaned, degreased and assessed for wear, all bearings removed, checked cleaned and regreased where appropriate. Frame then fully inspected and throughly cleaned and all parts refitted or replaced as necessary once customer has been advised of estimated cost. All cables will be replaced as part of this. The wheels will be fully trued and tensioned and any spokes that are broken will be replaced

Cost will vary for a full suspension mountain bike depending on the complexity of the rear suspension system and cycles with internal cable routing may also incur additional cost if difficult to recable. This does not cover fork or shock servicing on mountain bikes

Repair Menu

Puncture/Tyre fitting £6.00
Puncture/Tyre fitting hub gear £20.00
Wheel True From £12.00
Wheel True with spoke replacement From £20.00
Brake Bleed From £20.00
Transmission removal, degrease and refit and gear adjust From £40.00
Gear set up From £15.00
Brake pads fit £6.00
Headset fit £20.00
Bottom Bracket fit £20.00
Chain fit £8.00
Cassette/freewheel fit £8.00
Hub rebuild (bearings) From £20.00

We can do anything within a vast range and as such do not list all jobs, However we work on and hourly rate of £50 per hour with standalone jobs being priced based on approximate time to do. Additional cost may be incurred on seized worn or damaged parts where significant additional time is taken. If you want a more accurate quote please email via the contact page or ideally bring the cycle in for us to make a proper assessment.